This is the STL for the grid and collar. The grid needs to be printed with 0 top and bottom layers, then set the infill to “honeycomb” and adjust until you get the angle you want. I usually use between 8 and 25 percent.
Make sure you print these in high temperature filament if you’re going to use them on constant lights.
This is the STL for the grid and collar. The grid needs to be printed with 0 top and bottom layers, then set the infill to “honeycomb” and adjust until you get the angle you want. I usually use between 8 and 25 percent.
Make sure you print these in high temperature filament if you’re going to use them on constant lights.